Ligne 9 : |
Ligne 9 : |
| Here the first prototype build around the [https://shop.mchobby.be/fr/pico-rp2040/2271-kit-cansat-avec-raspberry-pi-pico-micropython-3232100022713.html Pico-Cansat-Kit]. | | Here the first prototype build around the [https://shop.mchobby.be/fr/pico-rp2040/2271-kit-cansat-avec-raspberry-pi-pico-micropython-3232100022713.html Pico-Cansat-Kit]. |
| | | |
− | [ENG-CANSAT-Pico-Kit-01.jpg](ENG-CANSAT-Pico-Kit-01.jpg) | + | [[Fichier:ENG-CANSAT-Pico-Kit-01.jpg]] |
| + | |
| + | This raw prototype shows how to build Aluminium stand-off from 5mm aluminium section. |
| + | |
| + | Thanks to a Hobby Lathe (Proxxon) and few trick it is possible to build a very strong can. |
| + | |
| + | [[Fichier:ENG-CANSAT-Pico-Kit-02.png]] |
| + | |
| + | Some very common material can be used to create a 0.10mm surrounding wall for the can ;-) |
| + | |
| + | [[Fichier:ENG-CANSAT-Pico-Kit-03.png]] |
| + | |
| + | |
| + | [[Fichier:ENG-CANSAT-Pico-Kit-04.png|480px]] |
| + | |
| + | |
| + | More details on this [https://arduino103.blogspot.com/2022/11/cansat-creer-des-entretoises-en.html '''complete blog post'''] (''french'') |
| + | |
| + | == Prototype 2 == |
| + | This second prototype try to creates a multi-level cansat around the [https://shop.mchobby.be/fr/pico-rp2040/2271-kit-cansat-avec-raspberry-pi-pico-micropython-3232100022713.html Pico-Cansat-Kit]. |
| + | |
| + | [[Fichier:ENG-CANSAT-Pico-Kit-10.png]] |
| + | |
| + | This example is based on a more advanced spacer set. |
| + | It also explore: |
| + | * Openning in the can (eg: for camera). |
| + | * Protecting the Lipo (at center of the can). |
| + | * Electronic on the top of the can. |
| + | |
| + | {{dbox-orange|Surprisingly the PCB material is quite harder to work than aluminium!}} |
| + | |
| + | |
| + | [[Fichier:ENG-CANSAT-Pico-Kit-11.png]] |
| + | |
| + | More details on this [https://arduino103.blogspot.com/2022/11/cansat-prototype-alu-2-partie-1.html '''complete blog post'''] (''french'') |
| | | |
| == 3D CanSat == | | == 3D CanSat == |