This raw prototype shows how to build Aluminium stand-off from 5mm aluminium section.
+
+
Thanks to a Hobby Lathe (Proxxon) and few trick it is possible to build a very strong can.
+
+
[[Fichier:ENG-CANSAT-Pico-Kit-02.png]]
+
+
Some very common material can be used to create a 0.10mm surrounding wall for the can ;-)
+
+
[[Fichier:ENG-CANSAT-Pico-Kit-03.png]]
+
+
+
[[Fichier:ENG-CANSAT-Pico-Kit-04.png|480px]]
+
+
+
More details on this [https://arduino103.blogspot.com/2022/11/cansat-creer-des-entretoises-en.html '''complete blog post'''] (''french'')
+
+
== Prototype 2 ==
+
This second prototype try to creates a multi-level cansat around the [https://shop.mchobby.be/fr/pico-rp2040/2271-kit-cansat-avec-raspberry-pi-pico-micropython-3232100022713.html Pico-Cansat-Kit].
+
+
[[Fichier:ENG-CANSAT-Pico-Kit-10.png]]
+
+
This example is based on a more advanced spacer set.
+
It also explore:
+
* Openning in the can (eg: for camera).
+
* Protecting the Lipo (at center of the can).
+
* Electronic on the top of the can.
+
+
{{dbox-orange|Surprisingly the PCB material is quite harder to work than aluminium!}}
+
+
+
[[Fichier:ENG-CANSAT-Pico-Kit-11.png]]
+
+
More details on this [https://arduino103.blogspot.com/2022/11/cansat-prototype-alu-2-partie-1.html '''complete blog post'''] (''french'')