Différences entre versions de « FEATHER-M0-FAQ »
Ligne 5 : | Ligne 5 : | ||
'''Mon Feather M0 n'est plus détecté sur mon système et il ne peut plus être programmé. A l'aide!''' | '''Mon Feather M0 n'est plus détecté sur mon système et il ne peut plus être programmé. A l'aide!''' | ||
− | + | Si quelque-chose survient et que votre Feather M0 n'est plus énuméré comme périphérique USB série (par exemple, vous exploriez les périphériques ATSAMD21 et accidentellement modifié votre configuration), ne paniquez pas il y a deux ou trois choses à essayer pour revenir à la normale. | |
* First try pressing the reset button twice like a mouse double click. The LED should start pulsing red to inform you the chip has entered its bootloader and is waiting a program upload. | * First try pressing the reset button twice like a mouse double click. The LED should start pulsing red to inform you the chip has entered its bootloader and is waiting a program upload. |
Version du 1 mai 2016 à 13:32
En cours de traduction/élaboration. |
Mon Feather n'est plus reconnu!
Mon Feather M0 n'est plus détecté sur mon système et il ne peut plus être programmé. A l'aide!
Si quelque-chose survient et que votre Feather M0 n'est plus énuméré comme périphérique USB série (par exemple, vous exploriez les périphériques ATSAMD21 et accidentellement modifié votre configuration), ne paniquez pas il y a deux ou trois choses à essayer pour revenir à la normale.
- First try pressing the reset button twice like a mouse double click. The LED should start pulsing red to inform you the chip has entered its bootloader and is waiting a program upload.
- The Feather M0 will show up as a new COM port device (if you haven't already installed the Windows drivers, do that!)
- Select the new bootloader COM port in the Arduino IDE
- Now try uploading a simple blink example from the Arduino IDE to see if that gets the board back into a good state.
If you don't get a pulsing red LED and the board doesn't enumerate as a serial device then something has happened to the bootloader. Unfortunately the best option in this case is to connect to the single-wire debug test points on the back of the board (the SWDIO & SWCLK pads) and manually reprogram the bootloader using a J-Link or ST-Link ARM programmer.
Source: Adafruit Feather M0 Basic Proto créé par LadyAda pour AdaFruit Industries. Crédit [www.adafruit.com AdaFruit Industries]
Traduit par Meurisse D. pour MCHobby.be
Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.