Hack-pycom-esp 32

Un guide de démarrage rapide

Let’s start with a quick description of what to do after you unpack your brand new toy. Our aim is not to bug you with complex details about it, but instead get you as quick as possible to the point you can start doing useful things with your device.

It is strongly recommended to update the firmware on your device before coding, this is described in section 1.3 below

This chapter will get you unboxed and ready to code in no time.

• Unboxing and the expansion board
• Connecting over USB
• Firmware Upgrades
• Micropython introduction
• Connecting the board and coding using Pymakr

If anyting goes wrong, there is a Troubleshooting section (version anglaise ici) that addresses the most common issues. In case of any doubts you can always ask questions in our forum de la communauté (pycom.io, anglais).

Déballage et carte d'extension

The only way to learn how to use something new is by doing. First, we need to put together the basic pieces:

• Look for the reset button on your module (located at a corner of the board).
• Look for the USB connector on your expansion board.
• Insert the module on the expansion board with the reset button pointing in the same direction as the USB connector.

It’s that simple! If you want to confirm your work, here’s a picture showing how to place your board properly on the expansion board:

If you prefer video tutorials, here is a video showing these steps. It applies to all our modules.

To extend the life of your expansion board, please be aware of the following:

• Be gentle when plugging/unplugging the USB cable. Whilst the USB connector is well soldered and is relatively strong, if it breaks off it can be very difficult to fix.
• Static electricity can shock the components on the device and destroy them. If you experience a lot of static electricity in your area (eg dry and cold climates), take extra care not to shock the device. If your device came in a ESD bag, then this bag is the best way to store and carry the device as it will protect it against static discharges.

Guide de la carte d'extension

The document explaining the hardware details of the expansion board can be found here (pdf, PyCom.io).

Brochage des cartes

Le brochage des cartes WiPy2 et Lopy sont décrit ici.

---

Tutoriel PyCom Getting started (ESP_32) sous copyright de Damien George et contributeurs en ce qui concerne MicroPython et/ou PyCom en ce qui concerne les informations relatives a WiPy et LoPy.

Tutoriel traduit par Meurisse D. pour MCHobby.be

Traduit avec l'autorisation de micropython.org - Translated with the authorisation of micropython.org

Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : «  Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.

L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.