Piles et accus pour alimenter des Pixels-Diode
Utiliser une Diode
Crédit: AdaFruit Industries www.adafruit.com
A single 1N4001 diode has about a 0.7 Volt drop across its leads. Wired to our 6 Volt battery pack (when using alkaline cells), this yields 5.3 Volts output. That’s within our 5V±10% target window, so this simple component addition is all that’s needed to use the battery pack with the LED strips and pixels.
This same solution can be seen in our Digital Programmable LED Belt Kit.
Diodes have a specific polarity, passing current in only one direction…the silver stripe is the + end. So we want to connect the + terminal from the battery pack to the “dark” end with no stripe.
This sequence is only needed if you’ll be using alkaline cells. If you know for a FACT that ONLY rechargeables will be used, this part can be skipped. If you’re unsure, or will use different cells at different times, add the diode. |
Montage
The black wire from the battery holder then connects to the ground wire of the LED circuit (or plug/receptacle, if you’ve installed one). This side is much simpler than the diode-equipped wire:
Source: Battery Power for LED Pixels ans Strips créé par Phillip Burgess pour AdaFruit Industries. Crédit AdaFruit Industries
Traduit par Meurisse D. pour MCHobby.be
Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.