Modifications

{{POLImage|Pololu-Romi-Arm-Assembler-14.png|480px|Romi-Arm}}

{{POLImage|Pololu-Romi-Arm-Assembler-14.png|480px|Romi-Arm}}

5. While the servo is easily accessible, now is a good time to install the short linkage on the lift servo horn. Start by aligning the linkage and inserting a 6 mm nylon spacer through the hole on both parts. Then, insert a 3/8″ #2-56 screw with a washer through the spacer and secure it with a #2 nut on the other side. All of the joints on the arm will use this same method (with appropriately sized screws and nylon spacers).

5. Tandis que le servo reste facilement accessible, c'est le moment idéal pour installer le raccord (le court) sur la palant du servo élévateur. Commencez pat aligner les raccords et insérez une entretoise en nylon de 6 mm entre les deux trous des éléments. Ensuite, insérez une une vis 3/8″ #2-56 avec une rondelle through the spacer and secure it with a #2 nut on the other side. All of the joints on the arm will use this same method (with appropriately sized screws and nylon spacers).

{{POLImage|Pololu-Romi-Arm-Assembler-15.png|480px|Romi-Arm}}

{{POLImage|Pololu-Romi-Arm-Assembler-15.png|480px|Romi-Arm}}