Modifications

{{traduction}}

{{traduction}}

{{ADFImage|Rasp-PiGRRL-2-Dernieres-connexion-01.jpg|640px}}

{{ADFImage|Rasp-PiGRRL-2-Dernieres-connexion-01.jpg|640px}}

Now we need to connect our gamepad PCB to the PowerBoost 1000C. We'll need two 26AWG (which is thicker than the 30AWG we've been using so far) that's about 14cm in length. Like before, strip and tin the ends of each wire. Then, let's slip on a long piece of heat shrink tubing to keep the two wires together.

Now we need to connect our gamepad PCB to the PowerBoost 1000C. We'll need two 26AWG (which is thicker than the 30AWG we've been using so far) that's about 14cm in length. Like before, strip and tin the ends of each wire. Then, let's slip on a long piece of heat shrink tubing to keep the two wires together.