| Ligne 20 : |
Ligne 20 : |
| | | | |
| | == Brochage du LCD == | | == Brochage du LCD == |
| − | # Ground | + | # La masse (Ground/GND) |
| − | # VCC - 5v not 3.3v | + | # VCC - l'alimentation 5v (et non du 3.3v!) |
| − | # Contrast adjustment (VO) from potentiometer | + | # Ajustement du contraste (VO) depuis un potentiomètre |
| − | # Register Select (RS). RS=0: Command, RS=1: Data | + | # Register Select (RS, registre de sélection). RS=0: mode commande, RS=1: mode donnée (''Data'') |
| − | # Read/Write (R/W). R/W=0: Write, R/W=1: Read (we won't use this pin) | + | # Read/Write (R/W, Lecture/Ecriture).<br />R/W=0: Ecriture (''Write''), R/W=1: Lecture (''Read'').<br />Nous n'utiliserons pas cette broche. |
| − | # Clock (Enable). Falling edge triggered | + | # Clock (Enable, activée). Activation lorsque le signal passe du niveau haut à bas (''Falling edge triggered''). |
| − | # Bit 0 (Not used in 4-bit operation) | + | # Bit 0 (non utilisé en mode 4-bit) |
| − | # Bit 1 (Not used in 4-bit operation) | + | # Bit 1 (non utilisé en mode 4-bit) |
| − | # Bit 2 (Not used in 4-bit operation) | + | # Bit 2 (non utilisé en mode 4-bit) |
| − | # Bit 3 (Not used in 4-bit operation) | + | # Bit 3 (non utilisé en mode 4-bit) |
| | # Bit 4 | | # Bit 4 |
| | # Bit 5 | | # Bit 5 |
| | # Bit 6 | | # Bit 6 |
| | # Bit 7 | | # Bit 7 |
| − | # Backlight LED Anode (+) | + | # Anode (+) de la LED du rétro-éclairage |
| − | # Backlight LED Cathode (-) | + | # Cathode (-) de la LED du rétro-éclairage |
| | | | |
| | == Diagramme de câblage == | | == Diagramme de câblage == |