Ligne 124 : |
Ligne 124 : |
| | | |
| [[Fichier:Boarduino-Souder-34.jpg]] | | [[Fichier:Boarduino-Souder-34.jpg]] |
| + | |
| + | Solder the jumper header in place. You won't need to clip because the leads are short already! |
| | | |
| [[Fichier:Boarduino-Souder-35.jpg]] | | [[Fichier:Boarduino-Souder-35.jpg]] |
| | | |
| [[Fichier:Boarduino-Souder-36.jpg]] | | [[Fichier:Boarduino-Souder-36.jpg]] |
| + | |
| + | Place the jumper/shunt as shown, so that its on the '''EXT''' pair of pins |
| | | |
| [[Fichier:Boarduino-Souder-37.jpg]] | | [[Fichier:Boarduino-Souder-37.jpg]] |
| + | |
| + | Take the board out of the vise and plug in a power source such as a 9V DC positive-tip wall adapter or a 9V battery with a 2.1mm barrel jack. You should see the green LED light up. |
| + | |
| + | If no LED lights up check: |
| + | Is the battery or wall adapter good? |
| + | Is it positive tip? |
| + | Is the diode in correctly? |
| + | Is the LED in correctly? |
| + | Are all the parts in place? |
| + | |
| + | I don't suggest continuing if you can't get the green LED to light as it indicates a problem! |
| | | |
| [[Fichier:Boarduino-Souder-38.jpg]] | | [[Fichier:Boarduino-Souder-38.jpg]] |
| + | |
| + | xxx |
| | | |
| [[Fichier:Boarduino-Souder-39.jpg]] | | [[Fichier:Boarduino-Souder-39.jpg]] |