Modifications

ADF-BOARDUINO-SOUDER (voir la source)

Version du 20 novembre 2012 à 22:30

993 octets ajoutés , 20 novembre 2012 à 22:30

aucun résumé de modification

Ligne 148 : Ligne 148 :

[[Fichier:Boarduino-Souder-38.jpg]]

−

~~xxx~~

+

Place the red LED '''D3''', taking care to make sure the long lead is in the positive-marked hole. Also place the matching 1K resistor '''R3'''

+

Also place the 16.00MHz ceramic oscillator '''X1''' (which is non-polarized) the third ceramic capacitor '''C2''' and the 10K resistor '''R1'''

[[Fichier:Boarduino-Souder-39.jpg]]

+

Solder and clip the leads

[[Fichier:Boarduino-Souder-40.jpg]]

Ligne 157 : Ligne 161 :

[[Fichier:Boarduino-Souder-42.jpg]]

+

Place the 28 pin socket. This is to allow you to replace the microcontroller if necessary. Make sure the notch in the socket matches the notch in the silkscreened image. In this picture, its on the right

[[Fichier:Boarduino-Souder-43.jpg]]

+

Solder in the socket by tacking two opposite corners and then soldering the rest of the pins. Press the socket into the board to make sure its flat up against it.

[[Fichier:Boarduino-Souder-44.jpg]]

Ligne 165 : Ligne 173 :

[[Fichier:Boarduino-Souder-46.jpg]]

+

Cut another header off, this time a 6-pin piece.

+

Place the 6mm reset button, the 6-pin ICSP header and the 6-pin strip for using an FTDI USB cable

[[Fichier:Boarduino-Souder-47.jpg]]

[[Fichier:Boarduino-Souder-48.jpg]]

+

Solder the parts in

[[Fichier:Boarduino-Souder-49.jpg]]

+

If you'd like to take advantage of the auto-reset capabilities added to the Arduino software, install ceramic capacitor '''C6'''.

[[Fichier:Boarduino-Souder-50.jpg]]

+

xxx

[[Fichier:Boarduino-Souder-51.jpg]]

Admin

Bureaucrates, Administrateurs

29 917

modifications

Modifications

ADF-BOARDUINO-SOUDER (voir la source)

Version du 20 novembre 2012 à 22:30

Menu de navigation

Rechercher