29 918
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 2 :
Ligne 2 : + + + + + + + + + + + + + + + + + + + + + + + + + + + +
TFT-TOUCH-SHIELD-v2-Connecter (voir la source)
Version du 9 janvier 2014 à 12:14
, 9 janvier 2014 à 12:14aucun résumé de modification
{{traduction}}
{{traduction}}
== Brancher ==
=== Sur un Arduino Uno ===
{{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-01.jpg|640px}}
Because the TFT is about the same size as an Arduino, we pre-assemble the shield in the factory. To use, simply place it onto your Arduino Uno/Duemilanove/compatible. No wiring, no soldering! Bam!
=== Sur un Arduino Mega/Leonardo ===
{{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-02.jpg|640px}}
Sur ces cartes, c'est le connecteur ICSP qui sera mis à contribution (celui à 2 x 3 broches).
Si vous utilisez un Mega ou Léonardo, vous devrez configurer le shield à l'aide des cavaliers de configuration (voir ci-dessous).
== Utilisation avec Mega/Leonardo ==
With just a little effort you can make this shield plug-n-play with the Mega/Leonardo. Look at the bottom of the shield and find the area with the 6 jumpers. Three of them are closed, and three are open. Solder close the three ICSP jumpers.
{{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-03.jpg|640px}}
You can then cut the small line in between the #11, #12, #13 pads. This will free up digital #11, 12, and 13 for you to use on the Leo or Mega.
That's it! No software or firmware hacking other than that is required.
{{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-04.jpg|640px}}
With this mod, the shield uses the ICSP header for data so make sure your duino (or stack of shields) has a ICSP plugged into the socket as above!
{{TFT-TOUCH-SHIELD-v2-TRAILER}}
{{TFT-TOUCH-SHIELD-v2-TRAILER}}