Rasp-PiGRRL-2-Montage
En cours de traduction/élaboration. |
Placer le PiTFT
En cours de traduction/élaboration. |
No class registered in CONVERSION_CLASS for section build-alert alert-danger
<div class="alert"> <i class='fa fa-exclamation-circle'></i> DO NOT insert screws all the way through standoffs! Reference the photo to see required depth.
Crédit: AdaFruit Industries www.adafruit.com
Connected PiTFT and Gamepad
Now our PiTFT display and Gamepad PCB are mounted to the case. Press the buttons on the PiTFT and Gamepad to test them and see they feel good. If the buttons get stuck, the gamepad isn't flush with the standoffs.
Crédit: AdaFruit Industries www.adafruit.com
Install Speaker
Let's go ahead and pop the speaker into the case. Lay the speaker over the cavity with the grill and press it down to snap it into place. The wire should be oriented in a position so it's not in the way of the corner standoff.
Crédit: AdaFruit Industries www.adafruit.com
Install Switch
Now if a good time to insert the slide switch into the bottom case. Take note of the OFF position of the slide and install it to your liking (I prefer down is OFF, up is ON).
Crédit: AdaFruit Industries www.adafruit.com
Test PowerBoost Circuit
Grab the lipo battery and plug in the JST connector to the JST port on the PowerBoost 1000C. Flip the slide switch on, and see if the circuit works! The blue LED indicates the battery is charged and the circuit is powered on.
If the LED doesn't light up, you either have a defective PowerBoost, or a short. You'll have to double check your wiring for short using a a multi-meter. If you have any issues or questions, please post it on support forums at <a href="http://forums.adafruit.com/">http://forums.adafruit.com/</a>
Crédit: AdaFruit Industries www.adafruit.com
Almost Done!
In the next page, we'll close up the case and finish the build!
Source: PiGRRL 2 - Make a portable Raspberry Pi 2 game console
Créé par les frères Ruiz pour AdaFruit Industries.
Traduction réalisée par Wrotny A pour MCHobby.be.
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.
Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com