Bluefruit-LE-Shield-Hardware

Commande matériel

The following commands allow you to interact with the low level HW on the Bluefruit LE module, such as reading or toggling the GPIO pins, performing an ADC conversion ,etc.:

AT+BAUDRATE

Changes the baud rate used by the HW UART peripheral on the nRF51822.

• Codebase Revision: 0.7.0
• Parameters: Baud rate, which must be one of the following values:
  • 1200
  • 2400
  • 4800
  • 9600
  • 14400
  • 19200
  • 28800
  • 38400
  • 57600
  • 76800
  • 115200
  • 230400
  • 250000
  • 460800
  • 921600
  • 1000000
• Output: The current baud rate

# Set the baud rate to 115200
AT+BAUDRATE=115200
OK

# Check the current baud rate
AT+BAUDRATE
115200
OK

AT+HWADC

Performs an ADC conversion on the specified ADC pin

• Codebase Revision: 0.3.0
• Parameters: The ADC channel (0..7)
• Output: The results of the ADC conversion

AT+HWADC=0
178
OK

---

Basé sur "Bluefruit LE Shield" d'Adafruit Industries, écrit par Kevin Townsend - Traduit en Français par shop.mchobby.be CC-BY-SA pour la traduction
Toute copie doit contenir ce crédit, lien vers cette page et la section "crédit de traduction".

Based on "Bluefruit LE Shield" from Adafruit Industries, written by Kevin Townsend - Translated to French by shop.mchobby.be CC-BY-SA for the translation
Copies must includes this credit, link to this page and the section "crédit de traduction" (translation credit).

Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com