29 836
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 16 :
Ligne 16 : + + + + + + + + + + + + + + + + + + +
Pololu-Romi-Arm-Assembler (voir la source)
Version du 5 octobre 2020 à 09:05
, 5 octobre 2020 à 09:05→Micro gripper with position feedback servo
{{POLImage|Pololu-Romi-Arm-Assembler-03.png|480px|Romi-Arm}}
{{POLImage|Pololu-Romi-Arm-Assembler-03.png|480px|Romi-Arm}}
4. Align the top micro gripper case with the bottom micro gripper case and press them together, ensuring the clips snap closed.
{{POLImage|Pololu-Romi-Arm-Assembler-04.png|480px|Romi-Arm}}
Your gripper subassembly is now complete! If you ever need to open the micro gripper case. you can gently lift on the clips and pull them apart. A small screwdriver can help get under the clip. Set it aside for now; you will attach it to the end of the arm once it is assembled.
{{POLImage|Pololu-Romi-Arm-Assembler-05.png|480px|Romi-Arm}}
== Robot Arm Kit for Romi assembly ==
{{ambox|text=Do not overtighten screws. The screws used in the joints of the arm should be firmly tightened, but not enough to deform the nylon spacers. Overtightening the screws can increase the friction in the joints and result in much higher loads on your servos, potentially leading to damage.}}
1. Since the servos will be mounted on top of the mounting holes for the standoffs, install the standoffs on the Romi expansion platform first. Start by putting the #2 nuts in the hexagonal holes shown below, and threading them onto the 1.5″ aluminum standoffs inserted through the mounting hole in the Romi expansion platform.
2. Do the same for the 1″ standoffs on the front of the platform. Note that you should be using the two mounting holes closer to the center of the chassis.
{{POLImage|Pololu-Romi-Arm-Assembler-10.png|480px|Romi-Arm}}