29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 79 :
Ligne 79 : + +
Pololu-Zumo-Shield-Arduino-assembler-shield (voir la source)
Version du 8 avril 2017 à 22:46
, 8 avril 2017 à 22:46→Contacts des piles
== Contacts des piles ==
== Contacts des piles ==
{{traduction}}
* Turn the chassis over and install the battery terminal contacts as shown in the picture below. The three double-contact pieces should be firmly pressed into place until they are flush with the interior surface of the battery compartment. The two individual contacts should be inserted into the battery compartment so that their solder tabs protrude through the holes in the top of the chassis; you might want to temporarily tape these two individual contacts in place until they have been soldered to the shield as described in the next step, or you can use a battery to temporarily hold them in place.
* Turn the chassis over and install the battery terminal contacts as shown in the picture below. The three double-contact pieces should be firmly pressed into place until they are flush with the interior surface of the battery compartment. The two individual contacts should be inserted into the battery compartment so that their solder tabs protrude through the holes in the top of the chassis; you might want to temporarily tape these two individual contacts in place until they have been soldered to the shield as described in the next step, or you can use a battery to temporarily hold them in place.