Différences entre versions de « Senseur IR Intervalometre »
(Page créée avec « {{SenseurIR-Nav}} == xxx == xxx {{ADF-Accord}} {{MCH-Accord}} ») |
|||
Ligne 1 : | Ligne 1 : | ||
{{SenseurIR-Nav}} | {{SenseurIR-Nav}} | ||
+ | |||
+ | OK now that we can read IR codes, lets make a basic project. The first one we will do is to make an intervalometer. An intervalometer is basically a electronic thingy that makes a camera go off every few minutes or so. This can be used for timelapse projects or kite arial photography or other photo projects. | ||
+ | |||
+ | [[Image:IR-INTERVAL-1.jpg]] | ||
+ | |||
+ | The camera we'll be using has an IR remote you can use to set it off (most higher-end cameras have these). | ||
+ | |||
+ | [[Image:IR-INTERVAL-2.jpg]] | ||
+ | |||
+ | First we will figure out the codes by reading the signal sent when the button is pressed. Then we'll take that data and make the Arduino spit out that code into an IR LED once a minute | ||
+ | |||
+ | OK step one is easy, point the remote control at the IR sensor and press the button, we got the following for our ML-L3 Nikon remote. | ||
+ | |||
+ | [[Image:IR-INTERVAL-3.jpg]] | ||
+ | |||
+ | |||
+ | Looks like the data sent is: | ||
+ | |||
+ | suite ici [http://learn.adafruit.com/ir-sensor/making-an-intervalometer] | ||
== xxx == | == xxx == |
Version du 4 septembre 2012 à 11:22
OK now that we can read IR codes, lets make a basic project. The first one we will do is to make an intervalometer. An intervalometer is basically a electronic thingy that makes a camera go off every few minutes or so. This can be used for timelapse projects or kite arial photography or other photo projects.
The camera we'll be using has an IR remote you can use to set it off (most higher-end cameras have these).
First we will figure out the codes by reading the signal sent when the button is pressed. Then we'll take that data and make the Arduino spit out that code into an IR LED once a minute
OK step one is easy, point the remote control at the IR sensor and press the button, we got the following for our ML-L3 Nikon remote.
Looks like the data sent is:
suite ici [1]
xxx
xxx
Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.