Différences entre versions de « ENG-CANSAT-MISSION1-RECEIVE »
Sauter à la navigation
Sauter à la recherche
(→Wiring) |
|||
Ligne 39 : | Ligne 39 : | ||
|} | |} | ||
− | == The | + | == The code explained == |
+ | Here some explanation about the {fname|mission1-serial-radio-capture.ino}} sketch used in the CanSat. | ||
+ | This Arduino sketch would: | ||
+ | # '''Wait for the serial connexion''' to be established before starting the sketch | ||
+ | # Collect the sensor data | ||
+ | # Send it to serial connexion | ||
+ | # Send it over the radio connexion | ||
+ | |||
+ | <div style="margin: 15px 0; background: rgba(255,204,102,.3); display: block; padding: 15px 15px 15px 15px; -webkit-border-radius: 2px; -moz-border-radius: 2px; border-radius: 2px; border: 1px solid #ff9900;" >Don't forget to update the radio frequency {{fname|RF69_FREQ}} and the encryption key {{fname|key[]}} </div> | ||
+ | |||
+ | First, the script will includes all the needed libraries. | ||
== Compile and upload == | == Compile and upload == |
Version du 30 octobre 2018 à 15:52
En cours de traduction/élaboration. |
Introduction
The following wiring will prepare the "Receiver Station" for the mission 1. From the "RFM69HCW Testing" section, we will use an Arduino UNO and RFM69HCW module to redirect the Radio Messages to the serial port.
Wiring
Feather M0 Express | RFM69 |
5V | VIN |
GND | GND |
11 | MOSI |
12 | MISO |
13 | SCK |
4 | CS |
3 | G0 |
2 | RST |
The code explained
Here some explanation about the {fname|mission1-serial-radio-capture.ino}} sketch used in the CanSat.
This Arduino sketch would:
- Wait for the serial connexion to be established before starting the sketch
- Collect the sensor data
- Send it to serial connexion
- Send it over the radio connexion
Don't forget to update the radio frequency RF69_FREQ and the encryption key key[]
First, the script will includes all the needed libraries.
Compile and upload
Select the proper board in the menu Tools -> Type of board : Arduino/Genuino UNO
Select the proper port in the menu Tools -> Port
Then press the "compile" button.
Written by Meurisse D. from MC Hobby - License: CC-SA-BY.