Différences entre versions de « ENG-CANSAT-V2-ASSEMBLY »
Sauter à la navigation
Sauter à la recherche
| Ligne 43 : | Ligne 43 : | ||
The base station also gets improvements. No more soldering this side too. | The base station also gets improvements. No more soldering this side too. | ||
| − | [[Fichier:ENG-CANSAT-V2-ASSEMBLY-20.jpg| | + | [[Fichier:ENG-CANSAT-V2-ASSEMBLY-20.jpg|480px]] |
Within the CANSAT-KIT the Rapsberry-Pico is ready to use and can be plugged onto an PICO Radio board. | Within the CANSAT-KIT the Rapsberry-Pico is ready to use and can be plugged onto an PICO Radio board. | ||
Version du 31 juillet 2025 à 13:44
Abstract
The original version of the CANSAT kit required many soldering operation. It's intimidating for newcomers with little experience with a soldering iron.
With the CANSAT V2 kit, things have been made easier than ever, no solder required!
Assembling the Cansat
Let's prepare the main CANSAT board.
|
Take the base board and orient the board to see the USB label on the left and the "Pico/MCU facing this side" in front of you. | ||
|
Grab the CPU board with the microcontroler facing front. | ||
|
Now, insert the MCU board onto the 2x20 pin connector. | ||
|
|
Even when not required yet, user can pick the Lipo battery then plug it into the 2 poles JST connector (facing the microcontroler).
| ||
|
Antenna must be connected before any communication attempt!
To do so, connect the µFl coaxial wire on the board then connect the demo antenna to the other side.
|
Assembling the base station
The base station also gets improvements. No more soldering this side too.
Within the CANSAT-KIT the Rapsberry-Pico is ready to use and can be plugged onto an PICO Radio board.
Connects the demonstration Antenna and you are ready to test.
|
xxx |
|
xxxx |
|
xxx |
Written by Meurisse D. for MCHobby