ENG-CANSAT-MISSION1-CAPTURE

De MCHobby - Wiki
Sauter à la navigation Sauter à la recherche

Wiring

The following Wiring is used to capture

  • Air temperature
  • Air pressure

And transmissing the information via the RFM69HCW radio module.

Wire the barometric sensor

The BMP280 is wired on the I2C bus of the Feather.

ENG-CANSAT-BMP280-wiring.png

Wire the temperature sensor

Connect the TMP36 sensor as follows:

  • The pin 1 (on the left) to a power source (3.3V),
  • The pin 3 (the the right droite) to the ground/GND.
  • The pin 2 (middle one) to the A3 analogue input.

ENG-CANSAT-TMP36-01.png

Wire the radio module

Finally wire the RFM69HCW radio as follows:


Written by Meurisse D. from MC Hobby - License: CC-SA-BY.