ENG-CANSAT-MISSION1-CAPTURE

Wiring

The following Wiring is used to capture

• Air temperature
• Air pressure

And transmissing the information via the RFM69HCW radio module.

Wire the barometric sensor

The BMP280 is wired on the I2C bus of the Feather.

Wire the temperature sensor

Connect the TMP36 sensor as follows:

• The pin 1 (on the left) to a power source (3.3V),
• The pin 3 (the the right droite) to the ground/GND.
• The pin 2 (middle one) to the A3 analogue input.

Wire the radio module

Finally wire the RFM69HCW radio as follows:

---

Written by Meurisse D. from MC Hobby - License: CC-SA-BY.