ENG-CANSAT-MISSION1-CAPTURE

De MCHobby - Wiki
Sauter à la navigation Sauter à la recherche

Introduction

The following Wiring is used to capture

  • Air temperature
  • Air pressure

and transmissing the information via the RFM69HCW radio module.

We recommand to follows

Wiring

Wire the barometric sensor

The BMP280 is wired on the I2C bus of the Feather.

ENG-CANSAT-BMP280-wiring.png

Wire the temperature sensor

Connect the TMP36 sensor as follows:

  • The pin 1 (on the left) to a power source (3.3V),
  • The pin 3 (the the right droite) to the ground/GND.
  • The pin 2 (middle one) to the A3 analogue input.

ENG-CANSAT-TMP36-01.png

Wire the radio module

Finally wire the RFM69HCW radio as follows:


Written by Meurisse D. from MC Hobby - License: CC-SA-BY.