ENG-CANSAT-V2-ASSEMBLY

De MCHobby - Wiki
Sauter à la navigation Sauter à la recherche

Abstract

The original version of the CANSAT kit required many soldering operation. It's intimidating for newcomers with little experience with a soldering iron.

With the CANSAT V2 kit, things have been made easier than ever, no solder required!

Assembling the Cansat

Let's prepare the main CANSAT board.

ENG-CANSAT-V2-CONTENT-10.jpg

ENG-CANSAT-V2-ASSEMBLY-10.jpg Take the base board and orient the board to see the USB label on the left and the "Pico/MCU facing this side" in front of you.
ENG-CANSAT-V2-ASSEMBLY-11.jpg Grab the CPU board with the microcontroler facing front.
ENG-CANSAT-V2-ASSEMBLY-12.jpg Now, insert the MCU board onto the 2x20 pin connector.
ENG-CANSAT-V2-CONTENT-10.jpg Even when not required yet, user can pick the Lipo battery then plug it into the 2 poles JST connector (facing the microcontroler).
As soon as the battery is connected it will start to discharge in the board. The discharge can be compensated:
  • either by plug in power on the USB connector.
  • either by shorting the pads of "PWR Enable" connector (MCU sill also shutdown).
ENG-CANSAT-V2-ASSEMBLY-14.jpg When required, plug the µFl antenna coax.


Assembling the base station

x

Written by Meurisse D. for MCHobby


MCHobby investit du temps et de l'argent dans la réalisation de traduction et/ou documentation. C'est un travail long et fastidieux réalisé dans l'esprit Open-Source... donc gratuit et librement accessible.
SI vous aimez nos traductions et documentations ALORS aidez nous à en produire plus en achetant vos produits chez MCHobby.
Récupérée de « https://wiki.mchobby.be/index.php?title=ENG-CANSAT-V2-ASSEMBLY&oldid=33892 »