ENG-CANSAT-V2-ASSEMBLY

De MCHobby - Wiki
Sauter à la navigation Sauter à la recherche

Abstract

The original version of the CANSAT kit required many soldering operation. It's intimidating for newcomers with little experience with a soldering iron.

With the CANSAT V2 kit, things have been made easier than ever, no solder required!

Assembling the Cansat

Let's prepare the main CANSAT board.

 

  Take the base board and orient the board to see the USB label on the left and the "Pico/MCU facin this side" in front of you.
  Grab the CPU board with the microcontroler facing front.
  Now, insert the MCU board onto the 2x20 pin connector.
450px Even when not required yet, user can pick the Lipo battery then plug it into the 2 poles JST connector (facing the microcontroler).
 
 As soon as the battery is connected it will start to discharge in the board. The discharge can be compensated:
  • either by plug in power on the USB connector.
  • either by shorting the pads of "PWR Enable" connector (MCU sill also shutdown).
  When required, plug the µFl antenna coax.


Assembling the base station

x

Written by Meurisse D. for MCHobby


MCHobby investit du temps et de l'argent dans la réalisation de traduction et/ou documentation. C'est un travail long et fastidieux réalisé dans l'esprit Open-Source... donc gratuit et librement accessible.
SI vous aimez nos traductions et documentations ALORS aidez nous à en produire plus en achetant vos produits chez MCHobby.
Récupérée de « https://wiki.mchobby.be/index.php?title=ENG-CANSAT-V2-ASSEMBLY&oldid=33887 »