Différences entre versions de « AdaFruit LOL Shield Liste »
Sauter à la navigation
Sauter à la recherche
(Page créée avec « {{LOLShield-Nav}} x {{MCH-Accord}} ») |
|||
Ligne 1 : | Ligne 1 : | ||
{{LOLShield-Nav}} | {{LOLShield-Nav}} | ||
− | + | == Quelques recommandations avant de commencer == | |
+ | * Lay out everything beforehand, and go through the directions at least once before you start. | ||
+ | * Keep your iron tip clean. I Highly recommend a brass tip cleaner. | ||
+ | * Use 60/40 flux core electrical solder, unless you have a good iron and know what you are doing. | ||
+ | * The joints should look like a “Hershey’s Kiss”, completely covering the pad. | ||
+ | * Do not over-heat things. It will only take 1-3 seconds at the most to solder a joint. | ||
+ | * Don’t abuse your tools. Use your tools for their intended purpose, and keep them maintained. This will dramatically improve the quality of anything you do. | ||
+ | * Double check your work. | ||
+ | |||
+ | == Liste des pièces == | ||
+ | |||
+ | [[Fichier:ADF-LOLShield-Content.jpg]] | ||
+ | |||
+ | Le kit contient les éléments suivants | ||
+ | * 1 carte PCB du LoL Shield (v1.5) | ||
+ | * 133 Leds (rouge, verte, blanche, etc en fonction du shield acheté). | ||
+ | * 1 pin header de 36 éléments. | ||
{{MCH-Accord}} | {{MCH-Accord}} |
Version du 28 mars 2012 à 21:40
Quelques recommandations avant de commencer
- Lay out everything beforehand, and go through the directions at least once before you start.
- Keep your iron tip clean. I Highly recommend a brass tip cleaner.
- Use 60/40 flux core electrical solder, unless you have a good iron and know what you are doing.
- The joints should look like a “Hershey’s Kiss”, completely covering the pad.
- Do not over-heat things. It will only take 1-3 seconds at the most to solder a joint.
- Don’t abuse your tools. Use your tools for their intended purpose, and keep them maintained. This will dramatically improve the quality of anything you do.
- Double check your work.
Liste des pièces
Le kit contient les éléments suivants
- 1 carte PCB du LoL Shield (v1.5)
- 133 Leds (rouge, verte, blanche, etc en fonction du shield acheté).
- 1 pin header de 36 éléments.
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.