Différences entre versions de « ENG-CANSAT-MISSION1-RECEIVE »
Sauter à la navigation
Sauter à la recherche
(→Wiring) |
(→Wiring) |
||
Ligne 38 : | Ligne 38 : | ||
| align="left" | RST | | align="left" | RST | ||
|} | |} | ||
+ | |||
+ | == The Receiver Code == | ||
+ | |||
+ | |||
+ | == Compile and upload == | ||
+ | |||
+ | Select the proper board in the menu '''Tools -> Type of board''' : Arduino/Genuino UNO | ||
+ | |||
+ | Select the proper port in the menu '''Tools -> Port''' | ||
+ | |||
+ | Then press the "compile" button. | ||
{{ENG-CANSAT-TRAILER}} | {{ENG-CANSAT-TRAILER}} |
Version du 30 octobre 2018 à 15:37
En cours de traduction/élaboration. |
Introduction
The following wiring will prepare the "Receiver Station" for the mission 1. From the "RFM69HCW Testing" section, we will use an Arduino UNO and RFM69HCW module to redirect the Radio Messages to the serial port.
Wiring
Feather M0 Express | RFM69 |
5V | VIN |
GND | GND |
11 | MOSI |
12 | MISO |
13 | SCK |
4 | CS |
3 | G0 |
2 | RST |
The Receiver Code
Compile and upload
Select the proper board in the menu Tools -> Type of board : Arduino/Genuino UNO
Select the proper port in the menu Tools -> Port
Then press the "compile" button.
Written by Meurisse D. from MC Hobby - License: CC-SA-BY.