Hack-ENG-MotorSkin-Piece
Before assembling the kit, we will check the various components.
The Motor Skin BASIC does contains the following items:
Detail | Quantity | |
Motor-Skin board |
The Motor-Skin board disponible ici chez MCHobby |
1 |
330 Ohms Resistor |
Resistor disponible ici chez MCHobby |
1 |
470 Ohms Resistor |
Resistor disponible ici chez MCHobby |
1 |
4.7 KOhms Resistor |
Resistor disponible ici chez MCHobby |
1 |
L293D |
H_Bridge used to control 2 motors (forward & backward). disponible ici chez MCHobby |
1 |
DIP 16 |
Dip support for the L293D chip (so you can easily replace the L293D if you break it) disponible ici chez MCHobby |
1 |
47µF Capacitor |
L293's regulation capacitor disponible ici chez MCHobby |
1 |
Diode Schottky |
Diode balancing back & forward the PyBoard power supply from Pyboard's USB and Motor-skin battery pack. Polarised item, the "-" (minus) is on the same side of silver band. disponible ici chez MCHobby |
1 |
220nF capacitor |
Decoupling capacitor for the motors. Used to eliminate the noise caused by the brush rubbing the motor collector. disponible ici chez MCHobby |
6 |
2.54mm male connector |
Used to connect the motors on the board. disponible ici chez MCHobby |
2 |
Female connector |
A strip of female connector (4 pins) to plug the ultrasonic sensor disponible ici chez MCHobby |
1 |
PinHeader |
Strip of male pinHeader. Used to plug your motor-skin on the PyBoard. You can replace it with a stacking Header disponible ici chez MCHobby |
1 |
Jack Connector |
Power supply connector (centre positive) disponible ici chez MCHobby |
1 |
Screw terminal |
Power supply terminal (screw terminal). Take care about the polarisation. Wiring it upside down would destruct the Motor-Skin. disponible ici chez MCHobby |
1 |
Small BLACK push button |
This tactile switch is used to report the "reset" signal on the motor-skin disponible ici chez MCHobby |
1 |
Small WHITE push button |
4 buttons free of use (to ease user interface creation). disponible ici chez MCHobby |
4 |
Si vous avez acheter le Motor Skin KIT, vous avez également reçu les éléments suivants
Description | Quantité | |
Régulateur 5V |
Le régulateur DC-DC 5V S7V7F5 de Pololu. Permet de produire une tension de 5V (500mA) depuis une source d'alimentation de 2.7V à 11.8V disponible ici chez MCHobby |
1 |
Senseur Ultrason |
Senseur ultrason HC-SR04, permet de mesurer des distances de 2cm à 4m disponible ici chez MCHobby |
1 |
Créé par Meurisse D. pour MCHobby.be - Created by Meurisse D. for MCHobby.be
Every reference, text extract of this document should be accompagned with the following credit text : « produced/translated by MCHobby (www.MCHobby.be) - shop for kit and componants » together with a link to the source (so this page). The credit text must be applied on every type of media.
The commercial usage of this text/translation/project's content may be subject to royality fee. In every use case, you must also have the agreement of the initial owner (concerns translation work and content reuse)