Différences entre versions de « PiFace2-Manuel-Relais »
Ligne 15 : | Ligne 15 : | ||
[[Fichier:PiFace2-Manuel-Relais-01.jpg]] | [[Fichier:PiFace2-Manuel-Relais-01.jpg]] | ||
− | === Cavaliers JP5 et JP6 | + | === Cavaliers JP5 et JP6 des relais === |
Remove JP5 and JP6 to disconnect the relay 0 and relay 1 (respectively). | Remove JP5 and JP6 to disconnect the relay 0 and relay 1 (respectively). | ||
Version du 16 mai 2017 à 20:36
En cours de traduction/élaboration. |
PiFace Digital 2 has two changeover relays in parallel with the first two outputs. Each relay is connected to three black screw terminals. The pins’ functions are shown in the diagram below and are labelled on the underside of the PiFace Digital 2.
- NC - Normally Closed contact
- CO - COmmon contact
- NO - Normally Open contact
The NC and CO contacts are electrically connected until the relay is activated, at which point CO changes over to be connected to NO.
The relays may be disabled by removing the appropriate jumper (JP5 and JP6) as detailed in Jumper settings.
Cavaliers JP5 et JP6 des relais
Remove JP5 and JP6 to disconnect the relay 0 and relay 1 (respectively).
This is useful if you just want to use only the open-collector or LED outputs and stop the clicking noise created by the relays when switching outputs 0 and 1.
Traduction basée sur le document Technical DataSheet produit par Farnell
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.