PiFace2-Manuel-Alimentation
En cours de traduction/élaboration. |
PiFace Digital 2 requires 3.3V to supply the integrated circuit (which requires negligible current), which it always takes from the Raspberry Pi®. The relays and LEDs require 5V to operate.
PiFace Digital 2’s 5V can be configured to be supplied (as detailed below in Jumper settings)
- Independently from the Raspberry Pi® via the power screw terminals
- From the Raspberry Pi’s 5V
- Via the power screw terminals, and used to power the Raspberry Pi
Warning: Never have separate power supplies for both the Raspberry Pi and PiFace Digital 2, when the power jumper is connected. |
Note: As discussed in the Output ports section PiFace Digital 2 does not supply power on its open-collector output pins or relay contacts! |
The top 3 set of terminals on the right of the board is used to supply or take power, with the top pin being 5V and bottom two ground. In many applications these do not need to be connected to anything, as the PiFace Digital 2 will be powered by the Raspberry Pi
Traduction basée sur le document Technical DataSheet produit par Farnell
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.