PiFace2-Manuel-Sorties
En cours de traduction/élaboration. |
The 8 orange screw terminals are open-collector (see below for more details) outputs used to control external components such as LEDs, lights or motors and are labelled on the underside of the board.
Indicateurs LEDs
The onboard LEDs can be used to show the status of an application running on the Raspberry Pi® without any additional components. They are also useful for debugging circuits and code to confirm intended output state.
Connexion des sorties
To wire up an external LED connect the anode (longer leg of the LED) to the 5V screw terminal.
Connect the other leg, via a resistor (typically 330 ohm for most LEDs), to an output terminal.
When you enable the output, PiFaceTM Digital 2 allows current from the 5V supply to flow to ground through the LED which causes it to light up.
Traduction basée sur le document Technical DataSheet produit par Farnell
Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : « Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.
L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.